Pages

Thursday, 3 January 2019

DIY Bedside Lamp - episode 227

Sometimes it good to have a small bedside lamp beside your bed that only puts out a little light. I personally don't see the need for a small portable sun when you wake up in the middle of the night and want a light. In fact a bright light is the last thing you want and in my experience it is worse than no light at all. Your eyes clamp shut while your pupils try and adjust. I'm sure an infomercial would have the subject stumble out of bed, tahe a wrong turn and plummet out a third story window.
That's why I decided to look for a small rechargeable LED light that has a warm color and easily adjustible. I hunted around and after eliminating the ones that didn't have batteries, gave out multi colored light like a night club I finally found one that suited my requirements.
I have to say that while it isn't very bright as such it really up a room enough to see and because these days I read from a phone or Tablet I don't really need a bedside reading lamp. 
The only problem with my light is that it is a really light, light. Stretch out your hand and you are just as likely to push it aside as you are to turn it on. It really needs a heavier base and it needs to look a lot less cheap. Adding the wooden base fixes both problems.



Click to Watch





Where did I get the light?
I found it on AliExpress and it is the only light that I could find that matched my requirements. At least the only one that I was confident from the description would do the job. The link below will take you too it but I don't know how long it will be available for.



http://bit.ly/2LNTjyt


So far I've had the light do a month and other than charging it when it arrived I haven't had to charge it since. The battery is meant to last 2.5 hours of contineous use at full brightness and it will be interesting to see when it next needs to be charged.

Want to make one?
For those who want to make one you can download the drawings using the links below.
Drawings are provided in Aspire, VCarve Pro  and DXF formats


http://bit.ly/2LLmpys


I hope you enjoyed this episode and I will see you next time.

Cheers
Peter








www.masso.com.au

No comments:

Post a Comment